Launch Special: 20% OFF All Products!

Ends Nov 30, 7:19 PM PHT

Per DTI Fair Trade Permit No. 8442440, Series of 2026

Putting Lyrics and Scripture on Your Church Livestream

How to send the same lyrics, scripture and graphics from your sanctuary screens to your livestream using NDI, SDI or RTMP.

ChristChant 2 min read
Putting Lyrics and Scripture on Your Church Livestream, ChristChant blog cover

Online viewers should see lyrics and verses as clearly as the people in the room. The trick is sending the right picture to the right place.

Three ways to get graphics into a stream

NDI sends video over your network to a streaming computer. It is flexible and needs no extra capture hardware, but depends on a good wired network.

NDI sources listed in ChristChant's Network and Streaming settings
NDI, SDI or Direct Live: every route starts in Network and Streaming.

SDI is a broadcast video connection into a switcher or capture card. It is very reliable for fixed installations.

RTMP lets software stream straight to a platform, which suits small teams with one computer.

Keep the stream separate from the sanctuary

What looks good on a projector (full-frame lyrics) may not suit a stream, where you might want lower-third lyrics over camera video. Pick software with independent layouts for each output so one change does not break the other.

One slide shown twice: the full Main page for the room and a lower third Overlay for the stream
One slide, two layers: the full slide for the room and a lower third for the stream.

Use the same content, once

Entering lyrics once and sending them to every destination avoids mistakes. ChristChant's broadcast outputs can run NDI and SDI at the same time, with RTMP for streaming directly. These are part of the Ultimate Halo plan; the pricing page lists what each plan includes.

The output map routing each screen to its own output
Route each screen to its own output from one place.

Add a countdown

A pre-service countdown gives viewers a clear start time. Browse church countdown videos in the motion store.

Test checklist

  1. Confirm the stream picture on a phone, not just on the booth monitor.
  2. Check text size and contrast on a small screen.
  3. Check audio levels and sync.
  4. Run through a full song and a scripture reading.

For more, see our guide to church livestream software.

Enjoyed this? Share it

More from the blog

All posts
The Sunday Gathering title slide on the projector, with the live camera behind it
New features4 min read

What's new in ChristChant 1.8.12

ChristChant 1.8.12 brings a new Camera panel (your camera behind any slide, a phone or an IP camera, one-key cuts and a camera layout for the stream), a built-in Video Editor, and the Slide Editor on Browser.

Try it

Run your next service on ChristChant

Lyrics, scripture, media and live control in one place, built for the volunteer running it on Sunday morning.